Assembly Instructions

I ship the storage box flat so that it is less likely to break during shipment.  Here is how to put it together once it arrives:
Separate the four sides from the wood they came with. Set the outer rim aside for later.
Place the bottom on a smooth, flat surface. Connect the finger joints on three of the sides. It should be a bit wobbly at this point.
Work the short end into the slots on the bottom. Don't push the long ends in too far yet. Note that the left side of the long end is still sticking up quite a bit.
Work the short end into the slots on the bottom. Don’t push the long ends in too far yet. Note that the left side of the long end is still sticking up quite a bit.
Place the other short end into the finger joints of the long sides.
Work the long ends and the remaining short end until they fit into their slots. You may need to move them in multiple directions, but really shouldn't be forcing anything at this point.
Work the long ends and the remaining short end until they fit into their slots. You may need to move them in multiple directions, but really shouldn’t be forcing anything at this point.
Place the top rim onto one of the short ends and barely slide it on.
Slowly work your way down the long sides. Move the sides to the front, back, right, and left in order to get all the tabs lined up with all the slots.
Turn the box over onto a smooth, flat surface and apply even pressure on the bottom until the rim is fully seated on all the tabs.
Turn the box over onto a smooth, flat surface and apply even pressure on the bottom until the rim is fully seated on all the tabs.

You’ve finished the hard part!

Get the magnets that came with the box and some superglue (not included).
Get the magnets that came with the box and some superglue (not included).
The magnets are polarized! Place them on another component to ensure that they're oriented to hold things together correctly (instead of repelling them) before you apply superglue.
The magnets are polarized! Place them on another component to ensure that they’re oriented to hold things together correctly (instead of repelling them) before you apply superglue.
Do one corner at a time.  Add a dab of glue and then seat the magnet in the hole...
Do one corner at a time.  Add a dab of glue and then seat the magnet in the hole…
Then (before the glue sets) flip the box over onto a smooth, flat surface and apply even pressure to push the magnet all the way in so that it is flush with the top. Repeat at each corner.
Then (before the glue sets) flip the box over onto a smooth, flat surface and apply even pressure to push the magnet all the way in so that it is flush with the top. Repeat at each corner.

TOS Assembly Complete

You’re done!